Product presentation

Fun To Do has developed this resin for an ultra high-end finish.

Specifically designed to get the most out of your DLP/SLA machine, carbon nano-particles allow you to print objects at the highest resolutions with a more matte finish.

Cure times are similar to any other Fun To Do resin .
Its exceptional resolution therefore does not limit its use to Top Down design printers.

Product Features

About Fun To Do resins

All Fun To Do resins are designed to be super fast!
Cure times of 0.5 seconds for 0.02 mm layers are easily achieved on standard DLP printers with a light source of approximately 240 Watts.

A wide range of responsiveness!
Resins Fun To Do have a very wide range of reactivity, it extends from very short wavelengths of 225 nm to wavelengths close to the visible of 415 nm. 
By incorporating a very good mix of photoinitiators and sensitizers, almost any light source can be used to initiate the polymerization process of our resins. 
No need to modify your DLP projector. 
Do you have an SLA laser machine, or perhaps a DLP printer with an LED lighting source? As long as the wavelength is between 225nm and 415nm, it will work, and it will work fast!
Besides the wavelength of the light source, several other factors are important, so please consult our product sheets. If you have any doubts about the compatibility of your machine with our resins, simply send us an email.

Fun To Do resins have very low shrinkage!
Where 3.5% is considered a low shrinkage, we have limited it to 0.5%.
It's basically what you see is what you get. 
3.5% seems to be small but if you take a 10cm object, 3.5% is 3.5mm (which is almost half a centimeter!) It's huge compared to the 0.5mm that resins Fun To Do reach.

Natural resistance to water and most chemicals!
Fun To Do resins have a natural resistance against water.
In liquid form they are highly hydrofobic. 
Once fully cured, there are virtually no chemicals that can dissolve them. 
In our tests, printed parts have withstood the elements and various chemicals for several years! 
To see which chemicals were tested, scroll further down.

Friendliness makes you want to build more!
When designing resins, Fun To Do has devoted a lot of effort to making the resin as user-friendly as possible. These efforts have resulted in a series of low-odor resins with minimal skin irritation.

Fun To Do resins are affordable and allow you to build more!
Using resins Fun To Do , you can afford to experiment, expand your knowledge about media, exposure times, material thickness without having to think about material costs all the time.

Chemical resistance
Fun To Do resins have been tested with a wide range of chemicals:

• White Spirit
• Alcohol / Ethyl alcohol
• Diluent
• Hydrochloric acid and various other acids
• Sulfuric acid
• Acetone
• Essence
• Isobutanol
• Xylene
• Lamp oil / Engine oil / Olive oil / Brake fluid
• Water

This list, not exhaustive, is always expanding: each new chemical product is tested by immersing a printed part in it for a week or two.

For your safety Wanhao France recommends handling this product with gloves and a spatula .